What To Do If; Tips For Saving Energy; Disposal Of Old Appliances - Gastro-Cool GCKW50 Instructions For Use Manual

12 What to do if... troubleshooting
The design of the appliance guarantees interruption-free operation and a long
service life. However, if a fault does occur during operation, check whether it can
be traced back to an operating error.
You can eliminate the subsequent faults by yourself by checking the possible
causes:
Fault Possible Causes
The appliance is Is the mains plug in the
not cooling. socket?
Has the fuse in the socket
been triggered?
The appliance Is the appliance aligned
is noisy when vertically and horizontally?
operating.
Water is pooling Has the temperature
at the bottom of regulator been set correctly?
the refrigerator.
Is the condensation
waterdrain blocked by dirt?
Is the condensation drain
blocked by bottles on the
bottom?
The appliance Is the appliance ventilation
is not cooling blocked?
correctly.
Wet panes. Is the device temperature
set too cold?
Is the humidity in the unit too
high?
34
Measures
Insert the mains plug correctly
in the mains socket, switch on
the fuse, if required call for
expert assistance.
Adjust the appliance using the
supports.
Flow noises in the refrigerant
circuit are normal.
Correct the temperature
regulator setting.
Clean the drain with a pipe
cleaner or a small brush.
Place the bottles on a shelf.
Clear the ventilation slot,
position the appliance with
sufficient space.
Set the temperature slightly
higher.
13 Tips for saving energy
Do not place the appliance close to stoves, heaters or other heat sources. With
high ambient temperatures, the compressor runs more frequently and for
longer. This leads to unavoidable high power consumption.
Make sure that there is sufficient aeration and ventilation at the appliance base
and to the back of the appliance. Ventilation openings must never be covered.
The door should only remain open for as long as required.
The door seals of your appliance must be fully intact so that the doors close
correctly.
Do not set the temperature any lower than required.
14 Disposal of old appliances
Ensure that old appliances are disposed of in an environmentally friendly
manner. Make disused old appliances unusable prior to disposal. Pull the mains
plug out of the socket and disconnect the plug from the mains cable.
This appliance is marked according to the specifications of the European
Disposal Regulations 2012/19/EU - WEEE. This ensures that the product
is disposed of appropriately. By means of environmentally friendly
disposal, you ensure that any damage to health caused by inappropriate
disposal is avoided. The bin symbol on the product or the accompanying papers
indicates that this appliance must not be treated like household waste. Instead,
it should be taken to a collection point for the recycling of electrical and electronic
equipment.
Disposal must be carried out according to the respective locally applicable
regulations.
For further information please contact your local authority or disposal company.
35