Tech Lighting tiella Sola Pack Installing page 2

S ola P ack
1. Take Inventory
— Unpack the box containing (1) Sola Head,
and (1) 20 watt 12 volt MR16 halogen bulb.
(1) SOLA HEAD
2. Install the Head
12
USE A MAXIMUM
MR16
FRONT COVER HALOGEN BULB
— Insert the pins of the MR16 bulb into the socket
holes on the head.
— Remove the cap from the head.
SOLA HEAD
— Pick the location the head will be placed on the rail system.
Head may be placed over any unoccupied rail joiners.
— If a head location falls directly over the joiner, remove
the plastic insulator from the inside of the head;
otherwise, skip this step.
(1) MR16 BULB
20
VOLT, WATT,
CAP
MR16 BULB
SOCKET
HEAD INSULATOR
Only remove the insulator
from a head connector if
it will be located over a
rail joiner.
— Slide the head onto the rail and screw the cap to
the connector. The connection must be flush with the rail
and tight.
3. Check for Loose Connections
— Turn on the system and let it run for 5 minutes.
— Turn the system off and carefully check all connection
points are not hot to the touch (warm is acceptable).
— If a connection is hot, be sure to firmly tighten the
connections.
It is normal for the halogen bulbs to generate heat.
Important Safety Instructions
4.
To reduce the risk of fire, electrical shock, exposure to
excessive UV radiation, or injury to person:
— Use this fixture indoors only.
— Do not look directly at the lighted bulb.
— Do not remain in light if skin feels warm.
— Risk of Fire: Use only the type of bulb and maximum
wattage indicated in this instruction manual.
— Never cover the halogen bulb and never place flammable
material close to your fixture.
— Never turn the fixture on and off by connecting and
disconnecting the halogen bulb.
— Do not touch the fixture shade while the fixture is on.
This surface is HOT.
— The MR16 bulb must have a protective front cover glass
SAVE THESE INSTRUCTIONS
NOTE