Control Panel - Electrolux EUC 29291 W User Manual

• Connect to potable water supply only.
Service
• Any electrical work required to do the serv-
icing of the appliance should be carried
out by a qualified electrician or compe-
tent person.
• This product must be serviced by an au-
thorized Service Centre, and only genu-
ine spare parts must be used.
Environment Protection
This appliance does not contain gasses
which could damage the ozone layer,

CONTROL PANEL

1
1. Alarm light
2. Pilot light
3. Action Freeze button
Alarm reset button
4. Action Freeze light
5. Temperature regulator
Switching on
Insert the plug into the wall socket.
The pilot light will light up.
Turn the Temperature regulator clockwise
to a medium setting.
Important! If the temperature inside the
appliance is too high the Alarm light will light
up.
Switching off
To turn off the appliance, turn the Tempera-
ture regulator to the "O" position.
Important! The Pilot light stay ON until the
appliance is disconnected from the power
socket.
Temperature regulation
The temperature is automatically regulated.
To operate the appliance, proceed as fol-
lows:
9) If a water connection is foreseen
9)
5
2 3 4
in either its refrigerant circuit or insula-
tion materials. The appliance shall not
be discarded together with the urban re-
fuse and rubbish. The insulation foam
contains flammable gases: the appli-
ance shall be disposed according to
the applicable regulations to obtain
from your local authorities. Avoid dam-
aging the cooling unit, especially at the
rear near the heat exchanger. The ma-
terials used on this appliance marked
by the symbol
• turn the Temperature regulator counter
clockwise to obtain warmer storage tem-
perature.
• turn the Temperature regulator clockwise
to obtain colder storage temperature.
A medium setting is generally the most
suitable.
The exact setting should be chosen keep-
ing in mind that the temperature inside the
appliance depends on:
• room temperature
• how often the door is opened
• the quantity of food stored
• the location of the appliance.
Action Freeze function
You can activate the Action Freeze function
by pressing the Action Freeze button.
The Action Freeze light will light up.
Important! This function stops
automatically after 52 hours.
It is possible to deactivate the function at
any time by pressing Action Freeze button.
The Action Freeze light will switch off.
High temperature alarm
Temperature increase in the freezer com-
partment (for example due to an earlier pow-
er failure or door is open) is indicated by:
• Alarm light flashing.
• sounding of buzzer.
The buzzer can be switched off by pressing
the Alarm reset button.
electrolux 13
are recyclable.