Table of Contents
Advertisement
Quick Links
Thank you very much for purchasing PIAA product.
Please read this entire manual before installation and use of this product.
For Installers
Please give this Installation Manual to customer after installing.
• Lighting laws vary state to state, check your
local laws before use.
• Do not splash water directly on the hot lamps, as this
may cause cracking of the lens due to dramatic change
in temperature.
• The lamps and relay harness are to be used only with 12 volt automotive
electrical systems.
• Using this light system while the engine is not running will drain the battery.
• Do not repeatedly turn the light system on and off as it will shorten the life
of the system.
• Some automobiles generate high voltage at start up and when it is turned off,
do not have lights on as you start or turn off your vehicle.
• Using the wrong bulbs may cause a malfunction, use only specified PIAA bulbs.
• When changing bulbs or lenses follow the lamp assembly/disassembly diagram.
• Leave at least 1/8" clearance between the lamps and the front spoiler,
as the heat may damage the spoiler.
Installation Instructions
525
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Piaa 525
Summary of Contents for Piaa 525
- Page 1 • Some automobiles generate high voltage at start up and when it is turned off, do not have lights on as you start or turn off your vehicle. • Using the wrong bulbs may cause a malfunction, use only specified PIAA bulbs. • When changing bulbs or lenses follow the lamp assembly/disassembly diagram.
- Page 2 CONTENTS One (1) PIAA preassembled relay harness with fuse and switch Two (2) PIAA 525 lamps with black stamped steel housing and mesh guard. One (1) PIAA one touch connector Five (5) wire ties One (1) piece of Velcro TOOLS...
- Page 3 • The installation area must be clean, and level with enough working space to do the job without distractions. • The PIAA 525 lamps are designed to be mounted upright. It is very important that you make sure that the “PIAA” etched in the glass reads right side up.
- Page 4 If the system works, securely fasten the relay boxes and fuse holders or tie them out of the way with wire ties. If the system does not come on, please contact your PIAA dealer for assistance. Aim lamps according to Light Aiming instructions on page 5.
- Page 5 WIRING DIAGRAM Battery Power: red=on / green=off Mode: red=high / green=low Not Supplied By PIAA Switch Power PIAA Supplied Connector Fasten Fuse Boxes So Wires Point Down Marker Lamp Power...
- Page 6 Driving lights should only be used with the headlamp high beams. LAMP SERVICE The PIAA 525 lamp comes preassembled and ready to use. The only reasons to disassemble the lamp is to change the bulb. To open the 525 lamp press the lens release button at the bottom of the lamp next to the mounting bolt.
- Page 7 LAMP SERVICE (CONT'D) Pull the lens unit from the housing. If the bulb is hot from use let it cool before touching or removing it from the lamp. To remove the main bulb (H4) unplug the socket from the back of the bulb. Release the wire retainer and pull the bulb out of the lamp.
- Page 8 PIAA product. PIAA reserves the right to change the design its products without any obligation to modify any previous product. This warranty gives you specific legal rights.
Need help?
Do you have a question about the 525 and is the answer not in the manual?
Questions and answers