Installation; Installation Environment; Installation Method - Panasonic WHS1 Series User Manual

Table of Contents

3 Installation

In order to meet the front panel protection classifications, proper installation procedure must be

followed:

・ the borders of the cutout must be flat

・ screw up each fixing screw until the plastic bezel corner get in contact with the panel.

・ the cutout for the panel must be of the dimensions indicated in this manual.

The IP66 is guaranteed only if:

・ max deviation from the plane surface to the cut-out: ≦ 0.5 mm

・ thickness of the case where is mounted the equipment: from 1.5 mm to 6 mm

・ max surface roughness where the gasket is applied: ≦ 120 μm

A：WHS1 Standard Model

B：Installation cut-out

(Notes)

・ The equipment is not intended for continuous exposure to direct sunlight.

・ The equipment is not intended for installation in contact with corrosive chemical

compounds.

・ Do not use tools of any kind (screwdrivers, etc.) to operate the touch screen of the panel.

・ The vents in the panel casing must not be obstructed.

Place the fixing brackets contained in the fixing kit.

Tightening torque: 0.75N･m or screw each fixing screw until the bezel corner gets in contact with the

panel.

PROGRAMMABLE DISPLAY WHS1 Standard Model

Table of Contents