Advertisement
13.
Troubleshooting
In the event that your system exhibits problems, this section will familiarize you
with the basic steps to troubleshoot the
problem as well as what information PACE
will require in order to give you the best
possible service.
1. The first step in troubleshooting is that
the system must be completely shut
down and re-started. You can do this
by turning the keyed power switch, located on the front of the system, to
the "Off" position.
2. Turn the power back on.
3. There are three categories that are used to troubleshoot the system:
Power: The power category covers all problems that include lack of
Video: The video category covers the problems that affect the presence
power to a component or to the full system. Power problems
would include:
- The system not powering up.
- The x-ray controller's red light does not turn on.
- The system's green light does not function.
?? Do all components power up when the main power
switch is turned on?
?? Do all power-indicating lamps turn on?
?? Do all power outputs show the proper voltage?
?? Is the foot pedal connected?
of a video signal from the x-ray camera. Video problems would
include:
- No x-ray image on the monitor, but x-rays are present.
- The image processor on the system does not boot up.
- The x-ray image is fuzzy or out of focus.
?? Is the video cable attached properly?
?? Does an X-ray image appear on the monitor when the
foot switch is depressed?
?? Does the systems image processor boot up?
Quick Tips
The first thing to do is to
simply try and re-start the
system. This can solve most
problems right away.
Page 18 of 23
Advertisement
