Subscribe to Our Youtube Channel
Related Manuals for Newco COMMERCIAL BARISTA Series
Summary of Contents for Newco COMMERCIAL BARISTA Series
- Page 1 Manual PN: 600769 Model: CBD 1.5 Solid State Relay SERVICE MANUAL COMMERCIAL BARISTA SERIES...
- Page 2 15-Feb-17 NEI 1.800.325.7867 www.newcocoffee.com [Manual #: 600769] P a g e...
- Page 3 Introduction The GXD Digital Series Brewers incorporate the latest features in brewer control technology along with the proven brewing system you have come to rely on. Although providing for enhanced functionality brewer controls remain intuitive and setup of key operating parameters couldn’t be easier. Multiple brew volumes, visa-brew delay, tank temperature set point, brew mode, filter parameters and more, are all set from the front control panel using a digital display for precise control.
- Page 4 Introduction (Continued) Audible Alert Mode – Provides an audible signal when coffee has finished brewing notifying everybody that fresh coffee is available. May be turned on or off and set for 1-9 beeps. Coffee Freshness Monitor – Monitors the elapsed time since the brew cycle to assure the coffee is fresh. Freshness time may be set for 10 minutes to 2 hours.
-
Page 5: Error Message
SEQUENCE OF PROGRAMMING STEPS FOR THE DIGITAL CONTROLLER TURN BY-PASS VALVE GREEN ADJUSTMENT SCREW CLOCKWISE TO CLOSE. TURN BACK OUT 4 FULL TURNS. THIS SHOULD GET 20 OUNCES OF BY-PASS. INCREASE OR DECREASE ACCORDINGLY. • Depress and hold Cancel and brew 1 button until display lights up (Approx. 10 seconds). •... - Page 6 Introduction (Continued) Error Messages The following table explains the error messages, which may be encountered, on the brewer. Going into the program mode, using the brew button to display “Cir” and then pressing the cancel button will clear the error messages. Error Message Description Cause...
-
Page 7: Installation Instructions
Installation Instructions Note: Cost of installation and any subsequent fine-tuning is the responsibility of the buyer. Warning: Read follow installation instructions before plugging in machine to an electrical outlet. 1. Remove the machine from shipping carton. It is strongly recommended to perform a visual inspection of the machine inside out checking for loose connections on either control board or for damage to outlet valve that might have been caused by mishandling during shipment. -
Page 8: Warranty
NEWCO’S SOLE OPTION AS SPECIFIED HEREIN, TO REPAIR, REPLACEMENT OR REFUND. In no event shall Newco be liable for any other damage or loss, including, but not limited to, lost profits, lost sales, loss of use of equipment, claims of Buyer’s customers, cost of capital, cost of down time, cost of substitute equipment, facilities or services, or any other special, incidental or consequential damages.
Need help?
Do you have a question about the COMMERCIAL BARISTA Series and is the answer not in the manual?
Questions and answers