Table of Contents
Advertisement
6.
Troubleshooting
FAULT
The programme does not start.
Water remains inside the
machine.
Machine stops during washing.
Shaking and hitting noises are
heard during a wash operation.
Partial food wastes remain on the
dishes.
Whitish stains remains on dishes.
Dishes do not dry.
Rust stains form on the dishes.
Detergent remains in the
detergent compartment.
POSSIBLE CAUSE
Your Dishwasher is not plugged in.
Your Dishwasher is not switched on.
Fuse blown.
Water inlet tap is closed.
Your Dishwasher door is open.
Water inlet hose and machine filters are clogged.
Water drain hose is clogged or twisted.
The filters are clogged.
The programme is not finished yet.
Power failure.
Water inlet failure.
The spray arm is hitting the dishes in the lower basket.
Dishes placed incorrectly, sprayed water not reaching
affected dishes.
Dishes leaning on each another.
Not enough detergent used.
Wrong wash programme selected.
Spray arms clogged with food waste.
Filters or water drain pump clogged or filter misplaced.
Not enough detergent used.
Rinse aid dosage and/or water softener setting set too
low.
High water hardness level.
Salt compartment cap not closed properly.
Drying option is not selected.
Rinse aid dosage set too low.
Stainless-steel quality of the dishes is insufficient.
High level of salt in wash water.
Salt compartment cap not closed properly.
Too much salt spilled in the Dishwasher while filling it with
salt.
A poor mains grounding.
Detergent was added when the detergent compartment
was wet.
DocNo.800-0401 - Troubleshooting - RDW6012 dishwasher
Switch your Dishwasher on by pressing the On/Off button.
Check the water inlet hose and machine filters and make
Check the drain hose, then either clean or untwist it.
Move or remove items blocking the spray arm.
Place dishes as instructed in the section on loading your
Use the correct amount of detergent, as instructed in the
Use the information in the programme table to select the
Clean the holes in the spray arms with thin objects.
Check the drain hose and filters are correctly fitted.
Use the correct amount of detergent, as instructed in the
Increase rinse aid and/or water softener level.
Increase water softerner level and add salt.
Check that the salt compartment cap is closed properly.
Select a programme with a drying option.
Adjust the water hardness level using water hardness
Check that the salt compartment cap is closed properly.
Use funnel while filling salt to the compartment to avoid
Consult a qualified electrician immediately.
Make sure detergent compartment is dry before use.
14
TROUBLESHOOTING
Plug your Dishwasher in.
Check your indoor fuses.
Turn on the water inlet tap.
Close the Dishwasher door.
sure they are not clogged.
Clean the filters.
Wait until the programme is finished.
Check mains power.
Check water tap.
Do not overload baskets.
dishwasher.
programme table.
most appropriate programme.
programme table.
Increase rinse aid dosage setting.
Use only dishwasher-proof sets.
table.
spillage.
Advertisement
Table of Contents
