Table of Contents
Advertisement
a You can see the cooking time counting down.
lights up.
a
a Once the cooking time has elapsed, the appliance
stops the operation and a signal sounds.
Notes
¡ If the water tank is empty, the appliance continues
to operate but without added steam. Nothing ap-
pears on the display.
¡ Opening the appliance door affects the cooking res-
ult. Always keep the appliance door closed when
cooking.
Changing the steam setting
▶
Press
until the required setting appears on the
display.
Note: Repeatedly pressing this switches through the
settings, from the highest to the lowest setting. After
the lowest setting, the steam function is deactivated.
Press again to activate the steam function, starting at
the highest setting.
11.4 Pausing the operation
1.
Press
or open the appliance door.
a The appliance stops the operation.
flashes.
a
2.
Close the appliance door.
3.
Press
.
a The appliance continues the operation.
lights up.
a
11.5 Stopping operation
You can stop operation at any time.
▶
Turn the function selector to the off position.
The fan may continue to run after operation has
been paused or stopped.
a The appliance stops any ongoing functions.
11.6 Filling the water tank
The water tank is located to the right behind the tank
cover, below the appliance door. Before starting an op-
eration with steam, open the tank cover and fill the wa-
ter tank with water.
WARNING ‒ Risk of fire!
Due to the hot surfaces, vapours from flammable li-
quids may catch fire in the cooking compartment (ex-
plosion). The appliance door may spring open. Hot
steam and jets of flame may escape.
▶
Do not pour flammable liquids (e.g. alcoholic drinks)
into the water tank.
▶
Only fill the water tank with water or with the descal-
ing solution we have recommended.
WARNING ‒ Risk of burns!
The water tank may heat up while the appliance is in
operation.
▶
Wait until the water tank has cooled down from the
previous operation.
▶
Remove the water tank from the tank recess.
Requirement: The water hardness must be set cor-
rectly.
→ "Setting the water hardness", Page 13
1.
Press on the centre of the tank cover.
a The tank cover opens.
2.
Remove the water tank from the tank recess.
3.
Fill the water tank with cold water up to the "MAX"
mark.
4.
Place the water tank into the tank recess and slide it
in fully.
Steam en
19
Advertisement
Table of Contents
