Table of Contents
Advertisement
CSRA-SVX01A-EN
Installation
Complete the "Installation Checklist" during installation to verify completion
of all recommended procedures before unit start-up.
Unit Assembly Dimensions and Weights
The 10 and 15 ton assembly dimensions and weights are provided in Figure
2 and 3 and Table 1.
Handling
Each assembly is mounted on an assembly base with forklift tube slots eas-
ily accessible for wide and narrow forklift trucks with suitable capacity. At
either end of the base is attached a tow-bar when additional pulling and
pushing maneuvering is required. There is also an overhead lifting frame
attached to the assembly base for overhead lifting without the need for addi-
tional spreader bars.
Drainage
Locate the unit so that the entire assembly can be allowed to drain during
unit shutdown and repair.
Rigging
Use a forklift, crane or helicopter of suitable capacity to move the unit to its
mounting.
Table 1: Unit Weights
Model No.
CSRA010FAF0
CSRA015FAF0
WARNING
Heavy Objects!
Do not use cables (chains or slings) except as shown. Each of the
cables (chains or slings) used to lift the unit must be capable of
supporting the entire weight of the unit. Lifting cables (chains or
slings) may not be of the same length. Adjust as necessary for even
unit lift. Other lifting arrangements may cause equipment or property-
only damage. Failure to properly lift unit may result in death or serious
injury. See details below.
Rig the unit using either belt or cable slings. Fasten the slings to the unit at
the four holes provided in the lifting frame. The point at which the slings meet
at the lifting hook must be at least 6 feet above the unit. Test-lift the unit to
ensure proper balance and rigging.
Tons
Shipping
Weight (lbs)
10 T
3800
15 T
4030
Operational
Weight (lbs)
3820
4050
9
Advertisement
Table of Contents
