22
Installation
4 Wrap the pipe with weatherproof tape. On vertical pipe runs, start the
wrap at the bottom and work up as shown in Figure 14. Be sure to over-
lap the tape so that it will shed moisture.
Note: If additional protection is required, insulate the pipe with fiberglass
wrap before installing the outer wrap.
CAUTION
Electrical Failure!
Do not install fiberglass insulation under the outer wrap when using
non-thermostatically-controlled heat tape. Failure to do so may result
in unit damage.
If freezing is a potential problem, all exposed piping, pumps and other com-
ponents must be similarly protected with heat tape and insulation.
Figure 14 — Typical Insulated Heat Tape Installation (Spiralled Applica-
tion)
CSRA-SVX01A-EN