Whirlpool WFC80602RT-D Service Manual page 14

Product
No Buttons
state
Reservation
Alarm
Maintenance mode
15 Spin Standby
Set
Running
Pause
Reservation
Alarm
Note :() indicates the unique buttons of the brand；
Whirlpool BLDC front load washer machine
Essential TRS washer
Mixed←→Wash&dry 60'←→Gentle←→Spin←→Stain
Eco cotton←→Wool←→Hot air refresh←→Sanitize wash←→
Essential TRS combo
Mixed←→Quick←→Gentle←→Spin←→Stain
Eco cotton←→Wool←→Allergy care←→Sanitize wash←→
3. Display type
Illuminated: the relevant display is constantly active at the top brightness.
Semi-illuminated: the relevant display is always active at 50% brightness.
Off: the relevant display is inactive.
Blinking: the relevant display flashes at 0.5s on & 0.5s off alternatively.
4. Special Functions
4.1 Automatic power-off
If the power is on and no any button operation within 10 min, the power will be turned off. During running, halting and
alarming, the automatic power-off function is off.
4.2 Automatic water level monitoring
The washing machine can automatically monitor the water level in standby status:
1) When the water level exceeds the overflow level (9 #), the drain valve is automatically opened until the water level is
below the water drainage level (2 #). EA2 alarm will be activated for 4 consecutive times, while all loads except the drainage
valve will be shut off;
2) When the water level is lower than the drainage water level (2 #), cut off all outputs and sound the alarm;
3) When the water level is higher than 80 mmWc, the heating pipes are allowed to operate. When the water level is lower
than 50 mmWc, the heating pipes will be forcibly turned off.
4.3 Cancellation of the finish beep
1. If set, the operation ends without beep sound.
2. Turn on the power. Press and hold "Start / Pause" key for 3 s. The 3 # beep sound prompts that the setting is completed. Repeat the
above operation to cancel it, and 2 # beep sound prompts that the cancellation is completed.
3. The function can be set or canceled when the washing machine is set or under running.
4.4 Midway clothes adding
① During the washing process, you can press "Start / Pause" button to activate the Midway Clothes Addition function.
② After the program is started, press "Start / Pause" button to halt the current running process. Simultaneously, the machine
detects whether the water temperature and water level meet the condition to unlock the door. If yes, "88:88" will display as
"add" and the door lock will release(the operator adding clothes is available). If the temperature inside drum is too high (>
50 degrees) or the water level is too high (> 105 mmWc), and the door lock icon is illuminated, door locked.
③ The water level for Midway Clothes Addiing unlocking is 105 mmWc, with locking level 120 mmWc.
④ When the water level inside the drum exceeds the locking level, the door lock is applied.
4.5 Child-proof Lock
1. After the child-proof lock is set, the washing machine door is in a locked state both during running or pause, and all the
buttons except the power button are not responding. If there is a button operation, the child-proof lock icon flashes 0.2 s on
Product
initial
current Operation and display
state
Reservation
Alarm
Maintenance See the inspecting specifications of the base board for
mode details.
Standby No response
Set Set the dehydration time. For details, refer to the logic
table
Running No response
Pause
Reservation
Alarm
Drum clean
Drum clean
14