Specifications - Orbit Behlman INV-1200 Series User's Manual And Technical Reference Manual

1.1

SPECIFICATIONS

INPUTS
MODEL
INV-1200 - 250 250 VDC +/- 20%
INV-1200 - 125 125 DC +/- 20 %
INV-1200 - 48 48 VDC +/- 20 %
OUTPUT
Power: 1200 Watts
Voltage: 120 VAC +/-2% 60 Hz (available @ 50 and 400 Hertz). Frequency +/- 0.1%
(220-240V output available with external transformer option. See option info.)
Current: 10 amps RMS continuous (30 amps peaks)
Waveform: Sine wave with less than 3% T.H.D. (linear load)
Efficiency: 80- 85% typical @ full load.
AC INPUT* *Optional bypass mode only. 130 VAC max @ 10 amps (fuse) see text.
PROTECTION
Input: DC circuit breakers (optional AC line bypass input has 10 amp fuse)
Output: Electronic over current protected.
Thermal: Thermal cut-out that monitors temperature. Shuts down during over-temp conditions.
Automatic Reset.
MECHANICAL
ENVIRONMENTAL
OPTIONS: A1- AC preferred option. Applies supplied line to the inverter output terminals under
normal conditions. If the AC line is lost, the inverter output will automatically be switched
to the output terminals to supply the load.
D1- DC preferred option. Inverter supplies load from the DC source under normal
conditions. If the DC source or inverter fails, the AC line will automatically be switched to
the output terminals to supply the load.
I = Transformer option. Provides 220-240VAC output at 50 or 60Hz. This option requires
an additional 2U chassis.
TB = Substitutes rear panel terminal block for NEMA 5-15R receptacles.
MNL940-677-000
DC INPUT DC BURDEN (full load)
7.5 AMPS @ 200 VDC
15 AMPS @ 100 VDC
40 AMPS DC @ 38 VDC
WIDTH: 17 in. (43.2cm) (19" standard EIA rack panel)
LENGTH: 17in. (48.3cm)
HEIGHT: 3.5in. (14.4cm)
WEIGHT: 25Lbs. (11.3kgs)
Operating temperature -20°C to +55°C, 95% RH non – condensing.
Available with all variants.
REV - B
3
DC BURDEN (no load)
270 mA +/- 20%
550 mA +/- 20%
1.7 A +/- 20%
3/20/2017