Advertisement
Calibration
calibrated at the factory. It should not need recalibration
unless it has been dropped or the angle reading is
obviously incorrect.
1. Place the Magnetic Angle Gauge level on a flat surface and
press the ON/OFF and ZERO buttons simultaneously until
"-1-" appears on the display.
2. Press the ON/OFF button again. The "-1-" should flash
briefly and then be replaced with "-2-". Do not move the
device until "-2-" is displayed.
3. Turn the Magnetic Angle Gauge horizontally 180°,
and then press the ON/OFF button. The "-2-" will flash
briefly. Do not move the device until calibration has
been completed.
4. Calibration is complete when the display stops flashing
and the readout shows 0.00 and ABS.
Check Rockler.com for updates. If you have further questions,
please contact our Technical Support Department
at 1-800-260-9663 or support@rockler.com
89409
Rev 04/21
The Magnetic Angle Gauge was
Distributed by Rockler Companies, Inc.
4365 Willow Dr. Medina, MN 55340
1-800-279-4441
www.rockler.com
Advertisement
