Advertisement
the Gauge in ABS mode; then move the center rule up to 1/8"
and push the "INC/ABS" button to switch to Incremental
Mode. The digital indicator will switch to "0". Tighten the
thumbscrew to secure the setting, set the bit height and make
the first pass. Now loosen the thumbscrew and slide the
rule until the digital readout displays 1/8" again. Tighten the
thumbscrew and use the Gauge to set the bit height for the
second pass – reaching a total depth of 1/4".
Using the Extension
The Digital Height Gauge comes with an extension that
stores on one of the gauge's legs. It clips onto the bottom of
the center rule to provide an additional 2" measuring capacity
below the guide, especially useful if measuring the depth of a
dado or mortise.
Troubleshooting
Problem
No display or
ambiguous reading
Number is flashing
Number skip or
frozen display
Possible Cause
Low battery,
no battery
or incorrectly
installed battery
Low battery
Internal error
Possible Solution
Reinstall or
replace battery
Replace battery
Remove battery,
wait one minute
and then
replace battery
11
Advertisement
