Standard Operating Mode - Display - Major XLR5 User Manual

2

Standard Operating Mode - Display

In the standard operating mode the display shows the following
information:
INP | MODE
The upper line is static. Below the text "INP", the letters A, B and C
ABC | HTPF
indicate a valid DMX signal present at the respective input.
ODE
If no signal is present at one of the three inputs, a line appears at the
ABC | F INP |
same position instead of the character.
MODE
In addition, for each input a possibly activated termination switch (for the
ABC | HTPF
120 Ohm line termination) is indicated by an underscore below the
relevant character.
Since the user can also hide the display (configuration menu), there are
two LEDs's on the front for visualizing the main device function for each
input.
The status of each input, where a valid DMX signal is present, is
indicated by slow flashing of the assigned green DMX LED.
If RDM communication (bidirectional) with the line at the output is
currently running via an input, the associated yellow RDM LED flashes.
The merger can only allow one input at a time for RDM communication
with the output line. The device decides which is ultimately the "winner"
with simultaneous RDM telegrams at several inputs based on the time of
RDM detection and a fixed, internal priority sequence (B > C > A).
The currently set MERGE MODE ("HTP" /"LOW" (LoTP) or "LTP") is
shown below the text "MODE", followed by the characters "F" / "M" or "S"
(for FAST / MEDIUM or SLOW) to indicate the speed of the output signal.
Version: 1.05, 05.10.18 5