Submenu 3,4,5 - Dmx Insert Address For Input A, B, C - Major XLR5 User Manual

7 Submenu 3,4,5 – DMX insert address for input A, B,
C
Via these 3 sub-menus, an insert address (OFF-SET) can be assigned to
each of the three inputs, from which the respective channel values are
then merged into the output values according to the set MERGE MODE.
Menu 3, Menu 4,
INPUT A – INPUT B – INPUT C –
Menu 5
or or
@ DMX: 001 @ DMX: 301 @ DMX: 451
With the "UP/DOWN" - keys the currently displayed address value can
now be changed either up or down. In this case, the value changes
slowly at first, and much faster in the corresponding direction after one
second. Click on the "OK" - key to save the settings.
Here is a possible application using the given example addresses:
A „large" lighting console controls at input A the entire DMX area of one
event location. A second, smaller lighting console has access to the
lighting circuits of the foyer at input B from DMX 301, but via its own DMX
channels from address 1.
A mobile dimmer controls temporaly added lights for object lighting from
address 451, which can be set with a simple 12 channel DMX console
without influencing the permanently installed circuits.
Please notice:
If the OFFSET address is changed for an input, the management table
for the "last value changes" is reset internally. All channels below the new
address are assigned the value 0 ("source unknown"), from and above
the address the assignment to the currently reconfigured input. If the
merger is working in LTP mode, this input temporarily takes over control
in its address range, all other values initially fall back to control through
input A.
12 Version: 1.05, 05.10.18