Safety Instructions; Assembly And Use; Maintenance And Storage - Strend Pro SS18 Instruction Manual

- All safety instructions in this manual must be taken into consideration and adhered to without exception!
Failure to adhere the safety instructions can result not only in danger to human health, but also to the
environment and the device itself.
-The outdoor solar shower is intended only for water showering for people.
- If used for other purposes or if any modifications are made to the device, the manufacturer is not liable for
any damage and any warranty is void on the device.
- For hygienic reasons, drain the water from the solar shower before or after a long period of non-use.
- If the water in the shower is not renewed regularly, microorganisms causing health problems may multiply
in it.
- The shower cannot contaminate public water with its use. It will be necessary to have protection installed
against the backflow of water into the public water supply network.
- The outdoor solar shower must not be used by people who are not familiar with the operating instructions
given in these operating instructions.
- Due to the fact that the water temperature inside the shower tube can reach 60 - 70 ° C, we recommend
turning the lever valve to the right first. By tilting it away from the body of the shower, a stream of cold water
is first released and only then, then the water is mixed to the desired temperature by turning the lever valve
to the left. This will prevent unwanted showering with hot water!
- After a certain period of non-use of the shower, even a small amount of water can be heated in the supply
hose to the tap. For safe use, it is first necessary to release a little water (approx. 3 seconds).
- Place the outdoor solar shower in a place with plenty of sunlight and within reach of the water connection.
- Mount it perpendicularly on a solid and horizontal surface. Best with 4 screws (part of the package) for
concrete or ceramic tiles, or wooden floor. Make sure the screws are tight. The construction of the shower
is massive and its fall could result in great damage.
- Mount the shoulder with the shower head to the outlet of the shower fitting on the front of the shower
tube.
- The shower fitting connection (3/4 ") opens in the bottom rear part.
- Turn off the water supply and connect the outdoor solar shower to the water supply. After connecting, turn
on the water supply.
- When connecting to the water supply, use adequate force and, if possible, tighten the connection by hand.
- Only use standardized, approved and undamaged plumbing fittings to connect the shower fitting
connection to the water supply.
- After connection, completely fill the shower tank with water and vent it at the same time:
• open the water supply valve and at the same time open the shower control lever to the open hot
water position and leave it fully open until water starts to flow smoothly from the shower head.
• Push the control lever to the "closed" position.
- Check valve connections for leaks.
- The outdoor solar shower is ready for use.
- It is forbidden to disassemble or modify the shower fitting connection.
- The outdoor solar shower does not require any special maintenance.
- Keep the solar shower clean and prevent limescale build-up on the surface.
- At the end of the season, disconnect the solar shower from the water supply, remove the drain plug located
at the rear bottom and drain all the water. When loosening, hold the sleeve in which the stopper is screwed
to prevent loosening.
- The control lever and shower head must remain dry.
- Wrap the control lever and shower head airtight against moisture. The solar shower treated in this way can
be left outside even in winter. However, we recommend storing the product in a disassembled state in a dry
place.

SAFETY INSTRUCTIONS

ASSEMBLY AND USE

MAINTENANCE AND STORAGE