Network Appliance FAS200 Series Hardware And Service Manual page 19

Chapter 1: Connecting a FAS200 Series Appliance
Step Action
8 Set the shelf ID to "1." The shelf ID switch on the back of the
appliance differentiates the FAS270 from additional disk shelves
connected to the system. For the FAS270 and FAS250, the default
and recommended setting for the ID switch is "1."
Attention
Power to the appliance must be off before changing the thumbwheel
switch value. The change takes effect after power is restored to the
appliance. Do not change the thumbwheel switch ID value while the
power is on.
9
If you are...
Adding disk shelves to your
FAS270
Not adding disk shelves to
your FAS270, or if your
system is a FAS250
Shelf ID switch
Then...
See "Connecting additional disk
shelves" on page 12.
See "Connecting your system to a
power source" on page 26.
7