Network Appliance FAS200 Series Hardware And Service Manual page 17

Chapter 1: Connecting a FAS200 Series Appliance
Step Action
5
If...
You are not attaching a third-
party device to the Fibre
Channel port
You are attaching a third-
party device, such as a tape
backup or a Fibre Channel
switch
6 Make sure that the 1 Gb/2 Gb switch is set to the 1-Gb position.
Then...
Plug in the SFP module, if needed,
and then insert the Fibre Channel
terminator, or loopback terminator,
into the Fibre Channel port at the far
left (Port C) of the CPU module.
Plug in the SFP module, if needed,
leave the Fibre Channel port
unterminated, and see
to third-party
1 Gb/2 Gb switch
"Connecting
devices" on page 27.
5