Advertisement
Advertisement
Table of Contents
Related Manuals for Autoplugin Key-V2
Summary of Contents for Autoplugin Key-V2
- Page 1 Autoplugin Key-V2 Version 9.8 User Manual Rev. D...
-
Page 2: Table Of Contents
Table of Contents Description …………………………….………………………………………. 3 Module Possibilities ………………………………………..………………….. 3 Package Content ……………………………………………………………….. 3 Connection …………………………………………………………………….. 3 Basic Functions ………………………………………………………………... 4 Additional Functions ………….……………………………………………….. 4 Troubleshooting …………………………………………………………….…. 7 Glossary CAN - Control Area Network (digital network for data transfer in vehicles) CIP - Combined Instrument Panel PCC –... -
Page 3: Description
Description The Autoplugin Key-V2 is an electronic module designed to add a remote control ability to the fuel-fired heater (parking heater, fuel operated heater, pre-heater), factory installed in Volvo S60 (2010-2018), V60 (2010-2018), V70 (2007-2016), XC70 (2007-2016), S80 (2007-2016) or XC60 (2008-2016). The device is plugged into the diagnostic socket, placed on the dashboard, and controls the heater via CAN-bus. -
Page 4: Basic Functions
Basic Functions 1. A special combination of buttons presses is used to start the heater with a remote control key. Firstly press “Lamp” button on the key to switch on the car’s lighting. Then press “Lock” button two times within 30 seconds, while lighting is on. - Page 5 If the entered digit is not correct, press and release “Read/OK” button until the module indicates an error. Enter the code once more in that case. Several codes can be entered without exit of setup mode. Turn the ignition off to exit from the Setup mode. New settings are saved in the non-volatile memory of the module and stored there regardless of whether the module is connected or not.
- Page 6 2.3. Number of 2.3.1 Combination is disabled sequential “Lock” 2.3.2 *Two presses button presses for 2.3.3 Three presses heater control (with 2.3.4 Four presses perimeter lighting turned on) 3.1. 3.1.1 * Not adjusted Battery Minimal battery 3.1.2 11.7V Monitoring voltage that lets the 3.1.3 11.8V module start the 3.1.4 11.9V...
-
Page 7: Troubleshooting
–The module turns off the heater if battery voltage lowers to the adjusted limit Troubleshooting If a run-time error occurs during the heater operation, Autoplugin Key informs about error code with LED flashing. The number of flashes in series corresponds to the error code. - Page 8 Make diagnostics of the heater connection or out of order The device is powered from the diagnostic socket. Therefore if there is no any indication on the module first of all check the car’s fuse for the diagnostic socket. © Autoplugin ES...
Need help?
Do you have a question about the Key-V2 and is the answer not in the manual?
Questions and answers