Cable Connections - Coby TFDVD1995S2 User Manual

Antenna/Power Connection
Connect TV RF sources to the Coaxial TV Antenna In jack. TV RF signals include: receiving antenna/
1.
CATV net. You can use 75 Ohm coaxial cable to connect outdoor antenna.
Insert one end of the supplied power cord to the player's power jack and the other end to a 110-240V AC
2.
wall outlet.
Note: Antenna requirements for good digital TV reception are
more important than those for analog NTSC TV reception.
For this reason, a high-quality outdoor antenna is strongly
recommended.
Wall Outlet 100~240V
VGA Input - PC Connection
The VGA port of the TV is capable of accepting high-definition signals from computers with a VGA output
jack. When used as a computer moniter, turn off both units, connect the VGA jack and the PC Audio In jack
with a 15-Pin D-Sub cable and a 3.5mm stereo audio cable. The mentioned cables are not included with this
product. After all neccessary connections have been properly made, turn on both units and use the SOURCE
button to select VGA.

Cable Connections

IMPORTANT NOTICE
1. Be sure to have all necessary connections properly done before connect
the power supply.
If you have difficulty inserting the plug, turn it over and re-insert it.
2.
If the product will not be used for a long period of time, disconnect the
3.
power. Note that the [POWER] button on the TV/remote control will place
the TV into the standby mode, it does not disconnect the device from
the main voltage. To completely disconnect the main voltage, please
disconnect the power plug from the wall socket.
7