Table of Contents
Advertisement
End Product Labeling
This transmitter module is authorized only for use in device where the antenna may be installed such that 20 cm may
be maintained between the antenna and users
(for example: Wireless Router, Wireless Access Point,
VP). The final end
product must be labeled in a visible area with the following:
"Contains TX FCC ID: KA2ACX100 ".
Manual Information That Must be Included
The OEM integrator has to be aware not to provide information to the end user regarding how to install or remove this
RF module in the users manual of the end product which integrate this module.
The users manual for OEM integrators must include the following information in a prominent location " IMPORTANT
NOTE: To comply with FCC RF exposure compliance requirements, the antenna used for this transmitter must be
installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or operating in
conjunction with any other antenna or transmitter.
15
Advertisement
Table of Contents
