Yamaha DBR Series Owner's Manual page 5

❚
Using the BBS251 baton bracket
Note In order to prevent the unit from falling down, attach the safety wire as
shown in the illustration.
Pullback point (only for DBR15 and DBR12)
• When the unit is shipped from the factory, a seal is stuck
on the pullback point (screw hole). Make sure to peel off
the seal when using the pullback point.
• The DBR10 does not have a pullback point.
Upper rear of the unit
Baton diameter
f f
34 - 51
Max. 45°
Pullback point
(M8 screw hole)
Securing the screws and eye
bolts
• Insert the screw or eye bolt through the
washer to attach them.
f
Apply thread-locking
fluid to the eye bolt