EAntenna 5070OWA9 Manual page 10

Feeding:
When the installation is fully completed, the last step is feed the antenna with coaxial cable. Follow the drawings.
Simply, cut and open the 2 coax and solder terminals supplied after placing these in the Driven element (DRV.6) and fixing
it with nuts and washers. The terminal position is irrelevant. Does not have to be alive or mesh on one side or another element.
Coax cable feeding:
After several trials, we see that the balun aluminum makes it worse job than a coaxial choke. For this, we recommend 5 turns
of 8 cm and thus the RF return will be minimal or absent.
In the drawing advise you to do the clash below the coaxial elements do not causes interaction with the elements.
COAXIAL
DE2
BOOM
DE1
Boom
ENGLISH
Outter Conductor Inner Conductor
Feeding Coax
REF