Operation - PAPILLON 97847 Instruction Manual

5.2. Fit the Nylon cutting head. Remove another shield after release the nuts as picture
showing. Still hold the flange, take the Nylon cutting head on the shaft and rotate
counter-clockwise, the Nylon cutting head is fitted.
5.3. Release the Nylon cutting head. Use screw driver to hold the flange and then rotate the
Nylon cutting head clockwise, it will be replaced.
Warning!
Please make sure the cutting head has been assembled correctly before use!
Note: The packaging material is made of recycle materials. Dispose of packaging materials in
accordance with regulations.

OPERATION

When operating this machine, please follow the instructions for operation steps
1. Filling with fuel
Danger of injury!
Fuel is explosive!
- Turn off and cool the motor down before filling the tank with fuel.
DANGER!
- You must observe all safety instructions relating to handing fuel.
Risk of device damage!
Before operating, you must fill it with fuel.
ATTENTION!
Never use oil for 4-cycle engine use or water cooled 2-cycle engine. If can cause spark plug fouling
exhaust port blocking or piston ring sticking. The oil to use is that for the 2-cycle air cooled engine.
Mixed fuels, which have been left unused for a period of one month or more may clog the carburetor or
result in the engine failing to operate properly. Put remaining fuel into an airtight container and keep it in
a dark and cool room.
Mix a regular grade gasoline (leaded or unleaded, alcohol-free) and a quality-proven
motor oil for air-cooled 2 cycle engines.
RECOMMENDED
GASOLINE 40: OIL 1
MIXING RATIO
GB
.
26