Advertisement

Quick Links

S71158F

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the S71158F and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Morris S71158F

  • Page 1 S71158F...
  • Page 2: Table Of Contents

    Contents SAFETY WARNINGS ......................1 INSTALLTION ........................3 Location ........................3 Reversing the Door Swing ..................3 Door Handle Install Illumination (optional) ............... 7 Door Space Requirements ..................8 Levelling the Unit ....................... 8 Cleaning Before Use ....................8 Before Using Your Unit ....................8 Interior Accessories ....................
  • Page 3: Safety Warnings

    1. SAFETY WARNINGS Warning : risk of fire / flammable materials THIS appliance is intended to be used in household and similar applications such as staff kitchen areas in shops, offices and other working environments; farm houses and by clients in hotels, motels and other residential type environments;...
  • Page 4 -Take off the doors. -Leave the shelves in place so that children may not easily climb inside. refrigerator must be disconnected from the source of electrical supply before attempting the installation of accessory. REFRIGERANT and cyclopentane foaming material used for the appliance are flammable.
  • Page 5: Installtion

    2. INSTALLΑTION 2.1 Location When selecting a position for your unit you should make sure the floor is flat and firm, and the room is well ventilated. Avoid locating your unit near a heat source, e.g. cooker, boiler or radiator. Also avoid direct sunlight as it may increase the electrical consumption.
  • Page 6 2) Remove the screws fixed the top-hinge with cross-slot screwdriver. 3) Replace the top-hinge and the top-door limit block and the door bearing bush to the other side. Remove the nut with sleeve .Take off the washer then remove the axes to the other side and fixed.
  • Page 7 4) Disassemble the screws fixed the bottom-hinge with hexagonal socket wrench . Note:the refrigerator-freezer incline angle less 45°. 5) Replace the bottom hinge to the other side then fix it with screws. 6) Set the door right position ,fix the mid-hinge .
  • Page 8 7) Replace the top-hinge. 8) Set the top door right position , fix the top-hinge and the cover. 9) Replace the leveler to the other side and adjust it to make sure the cabinet level.
  • Page 9: Door Handle Install Illumination (Optional)

    2.3 Door Handle Install Illumination (optional) Note: Figures in the user manual are only for reference. The actual product may differ slightly. The refrigerator must be disconnected from the source of electrical supply before attempting the installation of accessory. Step 1: take out two plug pins from the door (Side of door open) Step 2: Install the door handle to the door and fasten it with screws Step 3: Cover screw caps of the handle into screw holes...
  • Page 10: Door Space Requirements

    Door Space Requirements The unit's door must be able to open fully as shown. W×D≥902×1052mm Levelling the Unit To do this adjust the two levelling feet at the front of the unit. If the unit is not level, the door and magnetic seal alignments will not be covered properly.
  • Page 11: Interior Accessories

    You must check that you have a socket which is compa�ble with the plug supplied with the unit. ◆ Before Turning On! Do not turn on un�l two hours a�er moving the unit. 2.8 Interior Accessories Various plas�c storage drawers are included with your appliance - different models have different combina�ons.
  • Page 12: Operation

    4. OPERATION 4.1 Switching On Your Unit ◆The temperature selector knob is located on the middle of the upper beam. Setting“Min” :Less Cool Temperature Setting“Mid” :Normal Operation(adequate for most situations) Setting“Max” :Coolest Temperature ◆During high ambient temperatures e.g. on hot summer days. It may be necessary to set the thermostat to the Coolest setting(position “Max”).This may cause the compressor running continuously in order to maintain a low temperature in the cabinet.
  • Page 13: Cleaning The Interior And The Exterior Of The Unit

    or pipe)  You can also use the appropriate amount of hot water to speed up the defrost, with a dry towel to dry the water after defrosting.  After defrosting, put back the foods in cabinet, and power on the refrigerator. 5.2 Cleaning the Interior and the Exterior of the Unit ...
  • Page 14: Switching Of For Long Periods Of Time

    technician. 6.3 Switching Of for Long Periods of Time When the unit is not in use for a long period of time, disconnect it from the mains supply, empty all food and clean the appliance, leaving the door ajar to prevent unpleasant smells. 7.
  • Page 15: Tips For Energy Saving

    8. TIPS FOR ENERGY SAVING Warning for energy 1)Refrigerating appliances might not operate consistently (possibility of defrosting of contents or temperature becoming too warm in the frozen food compartment) when sited for an extended period of time below the cold end of the range of temperatures for which the refrigerating appliance is designed.
  • Page 16 Extended temperate: ‘this refrigerating appliance is intended to be used at ambient temperatures ranging from 10 °C to 32 °C’; temperate: ‘this refrigerating appliance is intended to be used at ambient temperatures ranging from 16 °C to 32 °C’; Subtropical: ‘this refrigerating appliance is intended to be used at ambient temperatures ranging from 16 °C to 38 °C’;...
  • Page 17 1420 97,1...

Table of Contents