Toro 04495 Operator's Manual page 2

1
2
1. Recessed bumper
Adjusting the Rear Roller
Scrapers
The rear roller scraper is adjusted at the factory, but can be
adjusted to meet turf conditions.
1. Loosen the locknuts securing the scraper to the frame.
2. Adjust the scraper until there is 0.75 to 1.5 mm (0.03
to 0.06 inch) clearance between the edge of the scraper
and the roller.
3. Tighten the locknuts securing the scraper.
Mounting the Tri-Rollers
1. Park the machine on a level surface, lower the lift arms,
stop the engine, and set the parking brake.
Note: If the carrier frames come equipped with
single-point pull frames, remove the pull frame and
attaching ball joint
G028062
Figure 2
2. Washer-head self-tapping
screw
(Figure 3).
1
1. Roller sets
2. Ball socket
2. Slide the tri-roller under the traction unit pull frame
while hooking the lift roller onto the lift arm
1
1. Lift roller
3. Mount the new pull link assemblies to the
Greensmaster 3200 and 3250 pull arms as follows:
A. Remove the screws securing the outside ends of
each anti-scalp roller shaft to each end of the
carrier frame (outside end of shafts only); refer
to Figure 3.
B. Assemble a jam nut and ball joint receiver onto
each pull link assembly as shown in
Figure 6.
2
2
G028063
Figure 3
3. Carrier frame
4. Pull frame
2
G010405
Figure 4
2. Lift arm
Figure 5
3
4
(Figure 4).
or