Lindy 39378 User Manual page 6

User Manual
Typical installation
OSD menu operation
To enter the OSD menu type the hotkey command SCROLL LOCK + SCROLL LOCK + SPACE in
Video setting
EDID setting
Select the EDID setting submenu and select the command Read monitor if your monitors are not yet
identified. They should be listed with their correct names. You can use the Load Default DDC command
to copy the factory default monitor DDC data to both the Transmitter and Receiver Units.
Password setting
Disable/Enable the password protection feature. After you logout or the Auto logout timeout has passed,
the console gets locked, and you will be prompted for your password before you can access the console
again. If you set a password, please make sure to note it in a safe place where you can find it in case
you forget it.
Auto logout: [0 ~ 60]
Disable / Enable the logout timeout (0~10min, 0 = Disable). The Auto logout time can be configured from
0 (Disable), with an increment of 1, right up to 10 Min. If the password protection is not enabled, the Auto
logout will not be put into operation.
Hotkey
The leading HOTKEY of the KVM Extender can be changed if there is any conflict with any other hotkeys
for example when connected to a KVM Switch. The available leading hotkeys are: CAPS, NUM, SCROLL
and F12. To change the leading hotkey either change it within the OSD menu or use the hotkey command
HOTKEY + HOTKEY + H + [new HOTKEY] - new one as above.
sequence followed after each other within less than 2 seconds.
Use the up/down cursor keys to navigate and press ENTER to
open the sub menus or right/left cursor keys to change options.
Select Video setting sub menu to adjust brightness, sharpness and skew
compensation (phase red and green). You may have to go through the
complete procedure several times. Changes have to be stored when
leaving the OSD.
English