Power Folding; Installing The Handlebars; Installing The Seat Ring - 4MOMS Origami 4M-006-01 Quick Start Manual

CHAPTER 1: POWER FOLDING
How to Power Fold and Unfold
To fold or unfold the Origami, turn the Outer Ring of
the Activation Dial counterclockwise until it won't
go any further, then release it. The dial will light up
for 5 seconds. While this button is lit, press the Power
Button and the stroller will fold or unfold.
If you press the Power Button while the dial isn't
lit, the stroller will not fold. The two-step process
prevents someone from folding the stroller
unintentionally.
1
There is a lock switch located at the base of the
Activation Dial (shown below). Slide the switch up
to lock the dial and down to unlock it.
12
2
CHAPTER 2: INSTALLING THE HANDLEBARS
1
CHAPTER 3: INSTALLING THE SEAT RING
Adult Assembly Required
This section deals only with the installation of your
included seat ring. The included seat ring is not
suitable for children under 6 months of age. If
installing an alternate 4moms
accessory, please see the instructions that came
with the accessory.
Step 1: Make sure the Origami is unfolded.
Step 2: Fit the Upper Attachment Socket of the seat
ring over the Upper Attachment Hub of the base,
and push to pin into place until it clicks.
Step 3: Do the same on the lower end.
Step 4: Buckle the seat restraint strap around the
Central Bar (as shown on page 3).
Detach the seat ring, by depressing the Release
Button on each of the seat's Attachment Sockets,
and pull each pin out as far as it will go.
English
2
approved seating
®
13