Storage; Troubleshooting - Steinbach Poolrunner Battery Basic Owner's Manual

10
1
12
1. Open all locking clips
2. Take the top part
1
3. Remove the filter unit
4. Thoroughly rinse the filter unit with plain tap water.
5. Rinse the device after each use with plain tap water inside and out.
The device is clean.

Storage

1. Thoroughly clean the device (see section "Cleaning").
2. Let all parts dry completely.
3. Fully charge the device.
Recharging is required after at latest 3 months due to self-discharge.
4. Then store the device and its accessories in a dry and frost-free place (≥ +5 °C) without direct
sunlight.

Troubleshooting

Fault description
The device cannot be switched on.
The charge control indicator is not
lit.
The device beeps.
The device continues beeping after
it has been placed in the water.
.
12
off.
.
2
Cause
The rechargeable battery is drained.
The rechargeable battery is
defective.
The ON/OFF switch has been
pressed out of the water. The device
beeps but does not switch on.
The charger is defective.
The device is out of the water.
The device is defective.
11
2
Remedy
Charge the rechargeable battery.
Contact customer service.
Place the device in the water and
wait 15 seconds until the device
turns itself on.
Contact customer service.
Place the device in the water.
Contact customer service.
27