CDA CVC10SS Manual For Installation, Use And Maintenance page 8

Programming
The coffee machine is equipped with a programming mode to enable you to set the following as required:
To enter programming mode follow the steps below:
1 Whilst the machine is off, press and hold
2.
Press
3. To change the setting, press
4. Press to exit programming mode.
Programming options are:
CLOCK – allows you to set the clock.
AUTO ON – allows you to set the time the coffee machine will switch on automatically.
Please note: you can switch on/off the Automatic switch on by pressing
switched off. The display will show an * next to the time.
AUTO OFF – allows you to set the time the coffee machine will switch off automatically.
Please note: you can switch on/off the Automatic Off by pressing
will show an * next to the time.
AUTO SHUT DOWN – allows you to set the number of minutes the coffee machine will be on before switching off
automatically. The options are 15, 30, 45, 60, 75, 90, or 0 for off.
POWER SAVING – allows you to set the length of time after which the coffee machine reduces the temperature
of the water heater to lower consumption. The options are 15, 30, 45, 60, 75, 90, or 0 for off.
DISPLAY – allows you to set the language on the display. The options are English, Italian, French, Spanish, Portuguese or
German.
WATER HARDNESS – allows you to set the hardness of the water used. To find out the water hardness in your
area, you should contact your water supplier. The options are 0, 5, 10, 15, 20, 25˚ d h. 1˚ d h = 1.786˚ F = 1.25˚ e = 17.86ppm
= 0. 1 786mmol/l)
DESCALING – shows the number of litres of water that have been dispensed and the theoretical level of limescale build
up based on the water hardness programmed. 100% indicates that descaling needs to be carried out. This
number will reset after descaling.
COFFEE – shows the number of coffees made since first use. This number cannot be reset.
GROUND COFFEE – allows you to set the quantity of ground coffee to make the coffee stronger or weaker. The
selection ranges from 6.0 - 8.0 sec – the coffee will be stronger the higher the number and 7.0 corresponds to the
preset factory level.
COFFEE TEMPERATURE – allows you to set the temperature for coffee. The selection ranges from -10˚ C to +10˚ C
and 86ºC corresponds to the preset factory level.
STEAM TEMPERATURE – allows you to set the temperature for steam. The selection ranges from -10˚ C to +10˚ C
and 150ºC corresponds to the preset factory level.
7
or until the required programme shows on the display.
or until the required setting shows on the display.
until PROGRAMMING shows on the display
when the coffee machine is
when the coffee machine is switched off. The display