Gate; Eq - Behringer X-32 Control User Manual

Gate

In gate mode, the channel selection is the same as explained above in config mode.
The treshold is adjusted by turning the second encoder button.
The gate is activated or deactivated by pressing the rec (clip) under this encoder
With the second encoder you can change the range. The rec (clip) button under it lets you change
the mode.
The next three encoders let you change the attack, hold and release.
The seventh encoder selects the sidechain filter type. Press and hold this button while turning to
select the source channel for this filter. The button under this encoder activates or deactivates the
sidechain filter.
The last encoder selects the frequency of the filter. The rec (clip) button under this encoder is the
solo button for the filter.

EQ

In eq mode, the channel selection is the same as explained above in config mode.
If an input channel is selected, the last 4 encoderknobs are used to set the gain of the respective eq
band (or parameter actually). Press and turn the encoderknob to change the frequency.
The second encoderknob selects the mode of the last 4 encoder knobs. In mode 1/2 they act as
described above. In mode 2/2 turn the last 4 encoders to change the bandwith (quality factor) of the
band. Press and turn the encoder knob to change the type of equalizer band.
Press the rec (clip) button under the second encoder to turn the eq on or off
The third encoder selects teh frequency of teh high pass filter. The rec (clip) button under it turns
the high-pass filter on or off
If a bus is selected, the last 6 encoder knobs are used for the 6 bands of the equaliser. There is no
high-pass filter on the busses.
Dyn
{to be completed }
Main
{to be completed }