Setting Up The Massage Lounger - Panasonic EP-MA82 Operating Instructions Manual

Setting up the massage lounger

1
Confirm that the main unit and the accessories are in
the box
Accessories
●
Controller stand
Controller
holder
2
Where to use the unit
Ensure there is adequate space to recline.
●
Dimensions required for installation ( see page EN51 for the detailed dimensions of the main unit)
Height 115 cm × Width 100 cm × Depth* 226 cm
* The main unit is approx. 206 cm in length, and it is necessary to keep it more than 10 cm from obstacles such as walls,
so a length of 226 cm should be reserved.
●
Do not expose the massage lounger to direct sunlight or high temperatures.
This can cause discoloration or hardening of the synthetic leather.
3
To set up
Move the unit by holding on the groove on the back cover
of the backrest.
(Groove position inside the back cover leather, need to lift
the back cover of leather.)
Hold onto the sides
Do not hold onto the
front side.
The sole massage
section might slide,
and injuries may
occur.
EN10
●
●
Pillow
Smart storage
●
Comfort cushion
Controller holder
fixing screw
Hold onto
Place your
the sides of
fingers in
the legrest.
the groove.
Legrest Back cover
●
●
Hex wrench
●
Lock switch key
This is initially inserted
in the lock switch of the
power switch section prior
to leaving the factory.
●
Since the unit is very heavy, be careful to avoid
back injuries. (The unit must be carried by two
or more persons.)
Product weight
To put the unit down on the floor
●
Put the unit down slowly watching your step
carefully.
●
Put down the legrest by holding it with your
hands until it has been set on the floor
completely. If you release your hands before
Groove
the legrest is fully extended, the legrest will
forcefully return to the initial position.
●
It is suggested to pave an article such as a mat
on the floor to keep it from damage.
Mat
Set screw
(four)
●
Power cord
Approx. 108 kg