Table of Contents
Advertisement
Problems
I pressed the power button but
the device doesn't switch off.
The unit does not respond
when I try to move the cursor.
What do I do to return to my
current position on the map
page after I have moved the
map?
The ONIX 110 fails to locate my
current position.
24
Troubleshooting
Possible Solution
Make sure that you hold the power button
for two seconds to turn it off. If the unit still
doesn't turn off, remove the battery or the
power source for five seconds and install it
again.
The map position may be latched. Check if
the
symbol is shown in the bottom right
corner of the map page. If so, press and hold
a direction key to unlatch the device.
Check if the
bottom right corner of the map page. Press
the ESC button to return to your current
position
Make sure that you are not in simulation
mode.
Make sure you are in an area with no
obstruction such as trees or tall buildings.
The ONIX 110 requires synchronization with
at least three satellites to identify with your
current location. Once the position has been
identified, it requires at least one satellite to
maintain status. If available satellite signals
are too low in orbit or all in a line, it may not
be able to locate your current location
symbol is showing in the
Advertisement
Table of Contents
