First Light SCL2 Series Quick Start Manual

WARNINGS: Please Read the Following Instructions Prior to Installation.
•
Install light in an area with direct sun exposure (minimum 2 to 3 hours of direct mid-day sun are required).
•
The solar module is made of glass, do not place directly onto ground.
•
Handle with care, scratches to powder coat will affect product appearance and durability.
•
If light was stored for more than 6 months, check the battery voltage to ensure that it is between 13.2V
and 13.6V. If the battery is below 13.2V, recharge with an appropriate lithium battery charger to maintain
the voltage above 13.2V
•
Use caution when handling 12v battery to avoid short circuiting the terminals against metal objects.
TOOLS REQUIRED: 1/8 Inch Hex Key

INSTALLATION PROCEDURES:

1.
Install footing with desired setback, typically 3 feet from path. Ensure pole location will be free of shade.
2.
Remove light from box using the cardboard liner and place it onto the cardboard liner with solar module
facing down.
3.
Using 1/8 INCH hex key screwdriver, loosen captive fastener as shown and open lid. Remove packaging
material, mounting kit, and batteries from the interior of the light. The batteries are attached to the
mount with velcro and may need to be pulled lightly.
4.
If pole is not pre-drilled, drill holes in pole as shown in drawing. (NOTE: drawing is not to scale)
5.
Install mounting arm onto pole path as pictured. Start by threading the threaded rods fully into backing
plate. Then, place mounting arm on the pole sliding the threaded rods through the holes.
1
First Light Technologies LTD.
Document 70-0030 03.August.2016
info@FirstLightTechonologies.com
© Copyright First Light Technologies Ltd.
SCL2 SERIES - SOLAR LED COMMERCIAL LIGHT
7/16 Inch Wrench
Pole
Setback
Path
4
2
Mounting Kit
Batteries
5
Backing Plate
Threaded Rod
PushNut
Mounting Arm
3
www.FirstLightTechnologies.com
1-844-279-8754 Toll Free