Download Print this page

Apex Digital Cirrus X2 Instructions

APEX

Cirrus X2 & X3

Instructions for frameless kit

Remove the burner tray from the fire box by the following steps shown below:

Fig 1. Carefully lift the the ceramic base

boards to reveal the burner screws

Fig 2. Remove 6 screws

Fig 3. Remove access panel

Fig 4. Disconect gas supply

Fig 5. Carefully remove the burner tray by lifting the back of tray first

Table of Contents

Need help?

Do you have a question about the Cirrus X2 and is the answer not in the manual?

Page 1 APEX Cirrus X2 & X3 Instructions for frameless kit Remove the burner tray from the fire box by the following steps shown below: Fig 1. Carefully lift the the ceramic base boards to reveal the burner screws Fig 2. Remove 6 screws Fig 3.
Page 2 You require to reposition the isolation bracket for frameless version Burner tray showing standard bracket Burner tray with framless bracket option 1. Remove bracket and retain the screws 2. Fold the new bracket to the shape shown 3. Fit the bracket using the new location holes as below 4.
Page 3 If using a back panel with this installation ensure the keys fit above the panel as shown in Fig 2 Fig 1 Fig 2 Plug the power supply cord into the USB socket on the side of the remote control valve ensuring the cord is routed away from any hot surfaces and the grommet provided is used to prevent chafing to the cord when passing through the fire box...
Page 4 Press to Decrease flame To Increase Flame Power Button The key mechanism will now give you manual control of the remote valve as shown above The keys have a small movement of approx 1mm Re fit the burner tray and fix in place the sub frame as shown below Fig 1 Fig 2 If you using the back panel kit for this installation it should be fitted now by following the instructuons that are...

Cirrus x3