Superfront TOP METOD Mounting Instructions

Content
3M wet wipe
3M
VHB™
Surface Cleaner Sachet
GB
For use with 3M™ VHB™ Tapes
Poche e de Ne oyage
FR
A utiliser avec les rubans 3M™ VHB™
Reinigungstuch
DE
Für den Einsatz mit 3M™ VHB™
Finished result
The result varies depending on the size of the frame.
Mounting
1.
Mount the wall brackets on the cabinet.
Mount the wall brackets supplied by Ikea before mount-
ing the Superfront sides. This is important so that the
top ends up in the right place on the cabinet.
BRACKET SPACER FOR BRACKET
2.
Clean the surfaces.
Use the a ached 3M wet wipe to clean the surfaces of
the cabinet and the Superfront top.
3M
VHB™
GB
FR
DE
Safety!
Be sure to always follow the safety instructions that apply to your furniture. Always secure the cabinet to the wall. This also applies to low cabinets where the weight
distribution changes drastically when the fronts open. Especially in the case of solid quality fronts as ours. Use the anchor brackets supplied with the Ikea cabinet.
Mounting instructions TOP METOD For One Side 1/2
MountPads 10x10mm
(The number varies depending on the size of the top)
FRONT VIEW
SPACER
Surface Cleaner Sachet
For use with 3M™ VHB™ Tapes
Poche e de Ne oyage
A utiliser avec les rubans 3M™ VHB™
Reinigungstuch
Für den Einsatz mit 3M™ VHB™
Superfront /+46 8 68 44 18 14 / info@superfront.com / www.superfront.com
3.
A ach the MountPads on the frame.
Place the frame on a hard, flat surface with the back-
side down. A ach one MountPad in each corner of the
cabinet top, inside the edges of the cabinet sides, and
spread the rest as shown at the bo om of this page.
Place them about 1 cm from the front and rear edge.
NOTE! Do not remove the cover paper from the Mount-
Pads yet!
MOUNTED SUPERFRONT SIDE
Continued on back page
BACK VIEW
ABOUT 1 CM
FROM THE FRONT
EDGE
NO MOUNTPADS
ON THE SIDE EDGES
ABOUT 1 CM
FROM THE BACK
EDGE
FLAT SURFACE