PowerXL VORTEX AIR FRYER PRO CM-005 Owner's Manual page 8

Using the Accessories
Skewer Rack Assembly
1. Insert each Skewer point through holes on the
left Skewer Rack (Fig. G).
2. Squeeze the clip end of each Skewer as you
insert into the opposite Skewer Rack slot to
secure.
3. Release clip to securely rest in slot as shown
(Fig. H).
4. Repeat steps 3–6 in a uniform manner around
the Skewer Rack. Make sure Skewers are evenly
spaced.
5. Ensure the Skewer Racks are inside the
indentations on the Shaft, tighten the Set
Screws and ensure they are securely in place.
6. Use caution while inserting the Shaft into the
appliance. The Skewer ends are sharp and can
poke you.
14
PowerXL Vortex Air Fryer Pro ™
Fig. G - LEFT SIDE Fig. H - RIGHT SIDE
FINAL ASSEMBLY
Using the Accessories
Placing Skewer Rack
or Rotating Mesh Basket
into Appliance
1. Insert the left side of the assembled Spit
or Basket first into the Rotisserie Shaft socket.
Be sure the Rotisserie Shaft is in place to
engage rotation (Fig. I).
2. Place the right side onto the hanger (Fig. J).
IMPORTANT: See the Final Assembly diagram
(page 8) to help identify the left and right sides
of the Rotisserie Shaft before placing it in the
appliance. The right side has two notches, and
the left has one.
Removing Skewer Rack
or Rotating Basket
from Appliance
1. Open appliance door to pause cooking
cycle or turn appliance off by pressing the
Power Button.
2. Insert Rotisserie Fetch Tool beneath the
Rotisserie Shaft.
3. Using the Rotisserie Fetch Tool, lift the right side
of the Shaft at a slight angle to clear the bracket.
Then, shift to the right until the left side of the
shaft slides out of the Rotisserie Shaft socket.
4. Carefully remove the rotisserie food from
the appliance.
5. Place food on a plate, cutting board, or the
Rotisserie Stand to remove food from the Shaft,
Spit, or Basket.
Fig. I - LEFT SIDE
Fig. J - RIGHT SIDE
15
PowerXL Vortex Air Fryer Pro ™