PowerXL VORTEX AIR FRYER PRO CM-005 Owner's Manual page 7

Using the Accessories
Placing Air Flow Racks
1. Insert the Drip Tray into the bottom of the
appliance (Fig. A).
2. Place Air Flow Racks into the appliance by
sliding them through the side grooves and
onto the back lip (Fig. B).
3. Place the Air Flow Racks closer to the top
heating element for faster cooking and
added crisp.
4. Rotate the Air Flow Racks mid-cycle for
even cooking.
12
PowerXL Vortex Air Fryer Pro ™
Fig. A
Fig. B
Using the Accessories
Using The Rotisserie Spit
1. With the Forks removed, force the Rotisserie
Shaft through the center of the food lengthwise.
NOTE: To support the food on the Rotisserie
Spit better, insert the Rotisserie Forks into the
food at different angles (see Fig. C).
2. Slide the Forks (A) onto each side of the Spit
and secure them in place by tightening the two
Set Screws (B).
3. Hold the assembled Rotisserie Spit at a slight
angle with the right side higher than the left side
and insert the left side of the Spit into the
Rotisserie connection inside the appliance
(see Fig. D).
4. With the left side securely in place, lower
the right side of the Spit into the Rotisserie
connection on the right side of the appliance
(see Fig. E).
5. To remove cooked food, insert a large fork
into the food, twist left, and raise to remove
the Spit from the left slot and then remove
the food from appliance with slight lifting
motion. Transfer the food to a carving board or
serving plate.
Removing Rotisserie Spit
1. Using the Fetch Tool, hook the bottom of the
left and right sides of the shaft attached to the
Rotisserie Spit (Fig. F).
2. Pull the Rotisserie Spit slightly to the right
to disconnect the accessory from the
Rotisserie Socket.
3. Carefully pull and remove the Rotisserie Spit
from the appliance.
A
B
Fig. C
Fig. D
Fig. E
Fig. F
13
PowerXL Vortex Air Fryer Pro ™