Advertisement
1. Bolt
2. Washer
3. Counterweight
4. Reel bearing locknut
5. Outer oil seal
6. Retaining ring
For Models with Removable Bearing
Housings
1. Remove the 2 locknuts securing the counterweight to
the right end of the cutting unit (Figure 3). Remove the
counterweight.
2. Remove the reel bearing lock nut from the right side
of the reel (Figure 3).
Note: The reel bearing lock nut has left hand threads.
3. Remove the 2 tapered nuts and plow bolts securing
each reel bearing housing to the cutting unit side plates
(Figure 3).
Note: If this kit is being used to retrofit the canister
seals to oil seals, a new bearing locknut and spacer
(Figure 3) are required. The oil seals in this kit require
the bearing locknut and spacer to have a 3.2 cm (1.25
7. Ball bearing
8. Wave washer
9. Thrust washer
10. Retaining ring
11. Shoulder bolt
12. Locknut
Figure 2
13. Inner oil seal
14. Flange head nut
15. Frame
16. Spacer
17. Spacer
18. Woodruff key
inch) outer diameter (old parts have a 2.8 cm (1.125
inch) outer diameter). Order part no. 107–3227
bearing locknut and 107–3228 spacer from you local
authorized Toro Distributor.
CAUTION
Contact with the reel, bedknife, or any other
cutting unit parts may result in personal
injury. Use heavy gloves when handling the
cutting unit.
Important: Support the reel to prevent it from
falling when bearing housings are removed.
4. Remove both of the bearing housings from the frame
and reel.
2
19. Reel drive pulley
20. Flange nut
21. Pitch arm
22. V-ring
23. Sleeve
Advertisement
