Attach L-Brackets And Eye Bolts - Fujitsu 5GRUDB3 User Manual

Installation
RU Installation
Note: This list of tools and accessories is the minimum required to install the RU. Depending on the situation,
more may be required. Any additional tools required for each installation procedure need to be identified and
prepared before starting installation.
Caution: The RU is heavy. Fujitsu recommends installing the RU
with a two-person team to avoid damage to the unit or injury to the
user.
4.5.2

Attach L-Brackets and Eye Bolts

This procedure describes how to attach the L-brackets and eye bolts to the RU.
Recommended Tools:
■ 13 mm socket
■ 5/8 in. wrench
■ Power tools (optional)
■ Metric and SAE toolkit
Note: If the RU is to be installed at a high location, Fujitsu recommends using lifting equipment to hoist the RU
by a pair of eye bolts mounted on the RU.
Step 1
With the RU on its side and using the Radio Bracket Kit (PCD4B780-0007-C001), install the L-brackets to each side
of the RU, securing them using the M8 screws, flat and split washers.
Note: Ensure proper L-bracket positioning on the RU. Refer to
Step 2
Torque each M8 bolt to 9.28 Nm to secure the L-brackets to the RU.
Step 3
Screw in two M8 eye bolts (PCD4B780-0008-C001) with flat and split washers in the two holes on top of the RU
and torque them to 13.4 Nm.
·
Issue 1.1, May 2021
Release 1.0
Attention: Le RU est lourd. Fujitsu recommande d'installer l'EF sur
une équipe de deux personnes pour éviter d'endommager l'appareil
ou des blessures à l'utilisateur.
Figure 13 for an example.
96
Fujitsu and Fujitsu Customer Use Only