Cleaning And Maintance - Xiaomi Jimmy AP36 User Manual

Table of Contents

Advertisement

Available languages

Available languages

  • ENGLISH, page 21
caused by filter replacement not in time. After replacing the filter,please keep pressing "Speed/Reset" button
for 5 seconds until the indicator lights off. Otherwise, the indicator light will be on all the time.
Timing
This machine provides three timing times(1h,4h,8h). Press the timing button once to set the time to 1
hour,press timing button twice for 4 hours, press timing button three times for 8 hours. Press again to cancel
and so on. This button is a loop button.When time is up, the whole machine stops running.

Cleaning and maintance

Filter cleaning and replacement
Note: Do not wash the multifunctional composite filter in water!
1. Proper care and cleaning of filter is critical to air purifier performance.
2. Follow the method in "Filter Removal and Installation".
3. Proper cleaning of multifunctional composite filter to increase filter life: Once every two weeks; Do not
wash with water;Clean with a vacuum cleaner brush or crevice tool on a newspaper or protective article;Do
not press the multiunctional composite filter hard when cleaning to avoid deformationl;
4. Replace multifunctional composite filter: When the indicator lights up, the user should replace the filter
within two weeks. According to the pollution degree and the use environment, the filter life is also different.
Machine cleaning and maintenance
1. Unplug before cleaning.
2. Increase cleaning frequency when use in dirty places.
3. Please wipe stains with soft cloth.
4. Please wipe indelible stains with a soft cloth with diluted neutral household cleaner and make sure the
machine is completely dry before reuse.
Infrared dust sensor cleaning
1. Clean infrared dust sensor regularly: suggest clean once every three months.
2. Open Infrared dust sensor cover;(Figure 8)
3. Clean infrared dust sensor: please use wet Q-tip to clean the lens, air inlet and air outlet,then use dry Q-tips
to remove the remaining water stains on the sensor;(Figure 9)
8
4.Install the infrared dust sensor cover in place.
Machine storage
Please unplug the power, clean and dry the machine, cover with a plastic bag and store in a dry place if the
machine is to be idled.
Note: Do not drag the power cord by hand. Please unplug the power cord hold by hand in case of cord
damage.
9
Air inlet
Air outlet
Lens
23

Advertisement

Table of Contents
loading

Table of Contents