DeLonghi ECP 35.31 Manual page 10

You are recommended to deliver steam for a
maximum of 60 seconds and never to froth
milk more than three times consecutively.
MAKING MACCHIATO (HOT MILK - MODEL ECP35.31
ONLY)
To make hot milk without froth, proceed as described in the
above section, making sure the ring on the cappuccino maker
(A10) is positioned upwards in the "HOT MILK" position.
CLEANING THE CAPPUCCINO MAKER AFTER EVERY
USE
Important! or hygiene reasons, the cappuccino maker
should always be cleaned after use.
Proceed as follows:
1. Turn the steam dial to the
a little steam for a few seconds (points 2, 6 and 7 of the
section "How to prepare cappuccino cofee"). This causes
the cappuccino maker to discharge any milk left inside.
Turn the appliance of by turning the steam dial to the 0
position and the mode selector dial to the l position.
2. Wait a few minutes for the cappuccino maker to cool down.
Turn the cappuccino maker outwards and remove it by
pulling it downwards (ig. 20).
Model ECP35.31
3. Remove the nozzle downwards (ig. 21).
4. Push the ring upwards and make sure the two holes shown
by the arrows in ig. 22 are not blocked.
If necessary, clean with a pin.
5. Replace the nozzle, move the ring downwards and put the
cappuccino maker back on the nozzle, turning it and push-
ing it upwards until it is attached.
Models ECP33.21 and ECP31.21
3. Remove the cappuccino maker nozzle downwards (ig. 23).
4. Make sure the holes in the cappuccino maker shown in ig.
24 are not blocked.
If necessary, clean with a pin.
5. Reinsert the nozzle and replace the cappuccino maker on
the nozzle, turning it and pushing it upwards until it is
attached.
HOT WATER
1. Press the ON/OFF button (ig. 4) to turn the appliance on.
Wait for the OK light to come on.
2. Place a recipient under the cappuccino maker.
3. When the OK light comes on, turn the mode selector dial
to the position and at the same time turn the
4. To stop the low of hot water, turn the steam dial to the 0
You should not deliver hot water for more
than 60 seconds.
CLEANING
Cleaning the machine
The following parts of the machine must be cleaned regularly:
-
-
-
-
-
position to deliver
•
•
an electrical appliance.
If the appliance is not used for more than 3/4 days, before using it again, we strong-
ly recommend you perform a rinse cycle as described in the section "Setting up the
appliance".
Cleaning the drip tray
The drip tray is itted with a level indicator (red) showing the
level of water it contains.
Before the indicator protrudes from the cup tray (ig. 25), the
drip tray must be emptied and cleaned, otherwise the water
may overlow the edge and damage the appliance, the surface
it rests on or the surrounding area.
1. Remove the drip tray (ig. 26).
2. Models ECP35.21 and 33.21: Remove the cup grille,
3. Put the drip tray back in place.
18
steam dial to the
of the cappuccino maker.
position and the mode selector dial to the l position.
the drip tray (A15);
the cofee ilters (C2, C3 and C4);
the boiler outlet (A13);
the water tank (A1);
the cappuccino maker (A7) as described in the section "Cle-
aning the cappuccino maker after every use".
Important!
Do not use solvents, abrasive detergents or alcohol to clean
the cofee machine.
Do not use metal objects to remove encrustations or cofee
deposits as they could scratch metal or plastic surfaces.
Danger! Never immerse the cofee maker in water. It is
Please note:
Models ECP35.31 and 33.21: Important!
empty the water and clean the tray with a cloth, then reas-
semble the drip tray.
Extract the mugs or glasses tray (A14), clean with water,
dry and put back in the machine.
position. Hot water comes out