JVC KD-SX24BT Instruction Manual page 17

BLUETOOTH®
To
While having two active calls...
End current call and activate
held call
Swap between the current
call and held call
Adjust the phone volume * 1
[00] to [35] (Default: [15])
Switch between hands-free
and private talk modes * 2
* 1
This adjustment will not affect the volume of the other sources.
* 2
Operations may vary according to the connected Bluetooth device.
Improve the voice quality
While talking on the phone....
1
Press and hold .
2
Turn the volume knob to select an item (see the following table),
then press the knob.
3 2
Repeat step until the desired item is selected or activated.
4
Press to exit.
To return to the previous setting item, press
MIC GAIN LEVEL –10 to LEVEL +10 (LEVEL –04): The sensitivity of the microphone
increases as the number increased.
NR LEVEL LEVEL –05 to LEVEL+05 (LEVEL 00): Adjust the noise reduction level
until the least noise is being heard during a phone conversation.
ECHO CANCEL LEVEL –05 to LEVEL +05 (LEVEL 00): Adjust the echo cancellation delay
time until the least echo is being heard during a phone conversation.
On the faceplate
Press and hold or the volume
knob.
Press .
Turn the volume knob during a call.
Press during a call.
.
Default: XX
Make the settings for receiving a call
1
Press to enter Bluetooth mode.
2
Turn the volume knob to select an item (see the following table),
then press the knob.
3 2
Repeat step until the desired item is selected or activated.
To return to the previous setting item, press
SETTINGS
AUTO ANSWER 01 SEC to 30 SEC: The unit answers incoming call automatically in the
selected time (in seconds). ; OFF: Cancels.
RING ILLUMI BLINK 01 to BLINK 05 (BLINK 02): Selects the blinking pattern for the
buttons as notification when there is an incoming call. ; OFF: Cancels.
Make a call
You can make a call from the call history, phonebook, or dialing the
number. Call by voice is also possible if your mobile phone has the
feature.
1
Press to enter Bluetooth mode.
"(First device name)" appears.
• If two Bluetooth phones are connected, press
to another phone.
"(Second device name)" appears.
2
Turn the volume knob to select an item ( 14), then press the knob.
3 2
Repeat step until the desired item is selected/activated or follow
the instructions stated on the selected item.
To return to the previous setting item, press
.
Default: XX
again to switch
.
13
ENGLISH