Control Panel Functions; Replace Batteries - Matco Tools Amp Hound 2 Owner's Manual

Amp Hound 2™ • AMP2 • Instructions
ON BUTTON
To turn the unit ON, depress ON button until 3 bars are displayed on the screen.
FUSE VALUE
Press and release this button to scroll through the fuse amperage options.
FUSE TYPE
Press and release the button to scroll through the fuse types (Mini, Std, Maxi)
ACCEPT FUSE DATA ENTRY
Press and hold either the FUSE VALUE or FUSE TYPE until the unit beeps twice
and the display is blank.
POWER UNIT OFF
Press and hold BOTH FUSE VALUE and FUSE TYPE until the unit beeps and
turns off. The unit will turn itself off after 10 minutes of inactivity.
SET-UP
Insert test leads or desired fuse adapter into banana jacks on the side of the unit.

REPLACE BATTERIES

1. Carefully remove the 4 screws from the back cover of the tool.
2. Remove the 3 batteries from the battery holder.
3. Replace batteries with 3 fresh alkaline AA batteries. Insert the batteries cor-
rectly in the holder using the proper polarity.
4. Replace the rear cover and 4 screws being careful not to over tighten the
screws.

CONTROL PANEL FUNCTIONS

Page 4
1602017-17MA