8) Lift up the board from NUT of Rear shield
* Caution : Handle with care to prevent USB Jack bending
i) Push board right bottom area to lift the board from
NUT.
Board
ii) Push board top bottom area to lift the board from
NUT.
iii) Push USB jack to lift the board from NUT.
NUT
NUT
NUT
- 17 -
9) Disassemble Vertically Board from Rear shield to prevent
USB jack bending and Check the USB jack Deformation
and bending or not
USB
Jack
* Reference : LCM, Chassis Frame status
LCM
Power PCBA
Copyright ©
-
LG Electronics Inc. All rights reserved.
Only training and service purposes.
M ain PCBA