遮陽篷的拆卸方法 Removing The Sunshade; 扶手保護套的拆卸方法 Removing The Front Guard Cover; 座椅縫製品的拆卸方法 Removing The Seat - Graco Citi Go User Manual

遮陽篷的拆卸方法
Removing the sunshade
②
①
❶將手把切換至對面。(請參閱P13) Switch the handle to rear-facing position. (See
P13)
❷收起遮陽篷。(請參閱P23) Close the sunshade. (See P23).
❸拉起左右兩邊卡榫下側的突起處向後輕扳即可自接口處拔出。Use your fingertip
to flick the tab at the bottom of the sunshade bracket.
‧安裝時請以相反順序進行安裝 Follow the steps in reverse order when installing
the sunshade.
扶手保護套的拆卸方法
Removing the front guard cover
❶打開開放型扶手。(請參閱P16) Open the
❷取出扶手保護套。Remove the front guard
‧安裝時請以相反順序進行安裝 Follow the
①
②
扶手保護套
Front guard cover
遮陽篷卡榫 Sunshade bracket
③
遮陽篷接口處 Sunshade holder
front guard. (Please See P16)
cover.
steps in reverse order when installing the
sunshade.
27
座椅縫製品的拆卸方法
Removing the seat
‧請勿讓寶寶乘坐於取下座椅縫製品的手推車上。因恐導致手推嬰
兒車損壞，或導致使用者、寶寶受傷等意外發生。
Do not use the baby stroller with the seat removed. There may
WARNING
be a risk of injury to your baby or other unforeseeable
circumstances.
〈準備 Preparation〉
請先將遮陽篷拆卸後再進行。(請參閱P27) Remove the sunshade. (See page 27)
③
②
①
⑤
⑥
④
❹解開座椅縫製品下方兩側的織帶固定扣(2處)。Unfasten the belt snap buttons
under the seat. (2 sides)
❺解開座椅縫製品兩側的織帶固定扣(2處)。Unfasten the belt snap buttons on both
sides of the seat.(2 sides)
❻解開座椅縫製品下方兩側的魔鬼粘(2處)。Unfasten the hook-and-loop fasteners
under the seat. (2 sides)
❶打開開放型扶手。 (請參閱P16 ) Open
the front guard. (See page 16)
❷按下股帶扣組解開鈕，卸下安全肩帶及
腰帶。 Press the buckle button to
unfasten the shoulder and waist
belts.
❸取出安全肩帶。Pull out the shoulder
belts.
織帶固定扣
Belt snap button
魔鬼粘
Hook-and-loop fastener
織帶固定扣
Belt snap button
28