Table of Contents
Advertisement
AAA-055-00020
Cutting and Mixing Procedures
Follow these procedures when using the machine:
1. Review the Pre-Operation checklist, as described in the 'Pre-Operation Checklist' section.
2. Review the location and function of all controls, as described in the 'Controls' section.
3. Transport the machine to the feed storage area.
4. Starting:
Always follow this procedure when starting the machine to minimize high startup loads:
a. Start the engine and run at low speed.
b. Engage the Hydraulic pumps to start auger.
c. Increase engine speed until the desired RPM is reached.
d. Proceed with loading of the ration.
5. Stopping:
a. Stop forward motion.
b. Close unloading door.
c. Stop conveyor when commodity is off.
d. Slow engine to low idle.
e. Disengage Hydraulic pumps.
f.
Stop engine if required.
6. Emergency Stopping:
If an emergency should arise, turn hydraulics off, stop forward motion and stop engine
immediately.
7. Loading Feed Rations:
a. Position the mixer where the loading machine has clear and easy access.
b. Start the machine (Refer to #5).
c. Begin adding ingredients to the mixing chamber in order to cut and mix a uniform feed
ration.
Important: Always remove twine, string, and wrapping material from bales and/or other
commodities from the ground that will be loaded into the mixing chamber. Failure to
follow these requirements can cause damage to the machine.
Important: It is recommended to add the light and fluffy ingredients into the mixing chamber
first. Then the heavier and denser material will force the lighter ingredients into the
mixture.
d. When adding ingredients, watch the numbers on the scale indicator to monitor the
weight of each ingredient as they are added.
e. Mixing times may vary depending on the ingredients being mixed. Typically, a total
mixed ration is achieved in 3 to 5 minutes beginning after the last ingredient is added.
Never enter the mixing chamber or go on the conveyor unless all controls are in
Danger:
neutral, engine stopped, park brake set, ignition key removed and all moving parts
JAY • LOR
Operator's Manual
- 32 -
Trailer Units
Advertisement
Table of Contents
