Makita GA5080 Instruction Manual page 10

4. Make sure the X-LOCK wheel is fixed correctly.
The surface of the X-LOCK wheel is no higher
than the surface of the holder as shown in the
figure.
If not, the holder must be cleaned or the X-LOCK
wheel must not be used.
► 1. Surface of the holder 2. Surface of the X-LOCK
wheel
To remove the X-LOCK wheel, push the release lever
from A side to lift B side, then pull the release lever from
B side as illustrated.
The X-LOCK wheel is released and can be removed.
A
► 1. Release lever
1
2
B
1
Installing or removing dust cover
attachment
Optional accessory
CAUTION:
Always be sure that the tool is
switched off and unplugged before installing or
removing the dust cover attachment. Failure to do
so causes damage to the tool or a personal injury.
There are three types of dust cover attachment and
each is used in one of different positions.
1
► 1. Marking A
► 1. Marking B
► 1. Marking C
Place the dust cover attachment so that the side of
the dust cover attachment with the marking (A, B or C)
faces towards the tool head. Snap the hooks of the dust
cover attachment in the vent.
10 ENGLISH
1
1